Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH


  1. Install the curtain shield airbag assembly LH with the 13 bolts in the order shown in the illustration.


    C128222E03

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag assembly LH when installing it.

  1. Install the clip.



    C141566
  1. Connect the connector to the curtain shield airbag assembly LH.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



3. INSTALL ASSIST GRIP RETAINER LH


    C128285
  1. Install the the assist grip retainer LH with the 2 bolts.



4. INSTALL ROOF HEADLINING

HINT:
Refer to the procedures from "INSTALL ROOF HEADLINING" (Click here).



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when disconnecting the cable from the negative battery terminal.



7. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).