Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. REMOVE ROOF HEADLINING

HINT:
Refer to the procedures up to "REMOVE ROOF HEADLINING" (Click here).



4. REMOVE ASSIST GRIP RETAINER LH


    C128285
  1. Remove the 2 bolts and the assist grip retainer LH.



5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH


    C128225E01
  1. Disconnect the connector from the curtain shield airbag assembly LH.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the clip.



  1. Remove the 13 bolts and the curtain shield airbag assembly LH in the order shown in the illustration.


    C128222E01