Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CRUISE CONTROL MAIN SWITCH


    E129554
  1. Install the cruise control main switch with the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the connector.



2. INSTALL STEERING PAD


    C128255E01
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the circumferencial groove of the "Torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using "Torx" socket wrench (T30), tighten the 2 "Torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.



3. INSTALL NO. 3 LOWER STEERING WHEEL COVER


    C128195
  1. Install steering wheel cover lower No.3.



4. INSTALL NO. 2 LOWER STEERING WHEEL COVER


    C128196
  1. Install steering wheel cover lower No.2.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. INSPECT SRS WARNING LIGHT
(Click here)