DTC Code
| DTC Detection Condition
| Trouble Area
|
C1421
| Either condition is met: Both of the following conditions continue for at least 1.2 seconds.
- The IG1 terminal voltage is between 9.5 V and 17.0 V.
- The VM/C1 terminal voltage is not within 4.4 V and 5.6 V.
Both of the following conditions continue for at least 1.2 seconds.
- The VM/C1 terminal voltage is between 4.4 V and 5.6 V.
- The PM/C1 terminal voltage is not within 0.19 V and 4.57 V.
| - Master cylinder pressure sensor circuit
- Master cylinder solenoid (Master cylinder pressure sensor, skid control ECU)
|
C1423
| Both of the following conditions continue for at least 5 seconds
- The stop light switch is off.
- The PM/C1 terminal voltage is below 0.3 V.
|
C1424
| One of the following conditions is met:
- Noise occurs in the signal from the PM/C1 terminal 7 times or more within 5 seconds
- When the vehicle speed drops from 40 km/h (25 mph) to 10 km/h (6 mph), the master cylinder pressure does not change by at least 0.048 MPa.
- At a vehicle speed of 7 km/h (4 mph) or more, the PM/C1 terminal voltage is between 0.86 and 1.0 V and master cylinder pressure does not change by at least 0.048 MPa for 60 seconds or more.
- At a vehicle speed of 7 km/h (4 mph) or more, the PM/C1 terminal voltage is 1.0 V or higher and master cylinder pressure does not change by at least 0.048 MPa for 30 seconds or more.
- At a vehicle speed of 7 km/h (4 mph) or more with the stop light switch ON, a state in which the master cylinder pressure sensor input value is sufficiently greater than the estimated master pressure continues for 1 second or more and this state occurs 5 or more times each time the ignition switch is turned to ON, and this occurs 8 or more times consecutively.
|
C1281
| Stored only during test mode.
|