TIRE PRESSURE WARNING SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (USING TECHSTREAM) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Read the DTCs.
| CHECK DTC (USING SST CHECK WIRE) |
Turn the ignition switch off.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
Read and record any DTCs from the tire pressure warning light on the combination meter assembly. Refer to the illustration above for examples of a normal system code and codes 13 and 33.
| Trouble Area | See page |
| Tire pressure warning light circuit |
Click here
|
| TC and CG terminal circuit |
Click here
|
Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.
![]() |
After completing the check, turn the ignition switch off and remove SST from the DLC3.
| *1 | DLC3 |
| *2 | Tire Pressure Warning Light |
| *a | Normal System Code |
| *b | ON |
| *c | OFF |
| *d | 0.25 seconds |
| *e | Code 13 and 33 |
| *f | 0.5 seconds |
| *g | 2.5 seconds |
| *h | 1.5 seconds |
| *i | 4.5 seconds |
| *j | Repeat |
| CLEAR DTC |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Clear the DTCs following the prompts on the Techstream screen.