FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FOR FUEL PUMP OPERATION AND FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump Speed / ON.
Check fuel pump operation.
Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.
| 2. CHECK FUEL PRESSURE |
Discharge the fuel system pressure (Click here).
Check the battery voltage.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| Positive (+) terminal - Negative (-) terminal | Ignition switch off | 11 to 14 V |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Remove the No. 1 fuel pipe clamp.
![]() |
Disconnect the No. 1 fuel pipe sub-assembly (Click here).
![]() |
Install SST (pressure gauge) using other SST as shown in the illustration.
| *1 | SST (Clip) |
| *2 | SST (T-joint) |
| *3 | SST (Hose) |
| *4 | SST (Fuel Tube Connector) |
| *5 | SST (Pressure Gauge) |
| *6 | SST (Pressure Gauge Hose) |
| *7 | Fuel Tube |
Clean up any spilled gasoline.
Connect the cable to the negative (-) battery terminal.
Operate the fuel pump.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump Speed / ON.
Measure the fuel pressure.
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
Disconnect the cable from the negative (-) battery terminal and carefully remove SST and the fuel tube connector to prevent gasoline from spraying.
![]() |
Connect the No. 1 fuel pipe sub-assembly (Click here).
![]() |
Install the No. 1 fuel pipe clamp.
Inspect for fuel leak (Step 1).