DTC P011B Engine Coolant Temperature / Intake Air Temperature Correlation |
| DTC No. | DTC Detection Condition | Trouble Area |
| P011B |
|
|

| Related DTCs | P011B: Engine coolant temperature / Intake air temperature sensor correlation |
| Required Sensors / Components (Main) | Engine coolant temperature / Intake air temperature sensor |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | - |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| All of following conditions met | Conditions 1 and 2 |
| 1. All of following conditions met | Conditions (a), (b) and (c) |
| (a) Soak Time | 7 hours or more |
| (b) Battery voltage | 10.5 V or more |
| (c) Time after engine start | 494 seconds or more |
| 2. Either of the following conditions are met | Condition (a) and (b) |
| (a) Minimum IAT after engine start | -10°C (14°F) or more |
| (b) ECT before engine start | -10°C (14°F) or more |
| IAT sensor circuit fail (P0112, P0113) | Not detected |
| ECT sensor circuit fail (P0115, P0117, P0118, P0125) | Not detected |
| Soak timer circuit fail (P2610) | Not detected |
| Deviated ECT and IAT | Less than -20°C (-36°F) or more than 20°C (36°F) |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P011B) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P011B is output | A |
| P011B and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (INTAKE AIR TEMPERATURE) |
Leave the vehicle for 7 hours or more.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Intake Air.
Read the value displayed on the Techstream.
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Coolant Temp.
Read the value displayed on the Techstream.
|
| ||||
| OK | ||
| ||