FRONT DIFFERENTIAL CARRIER ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY |
![]() |
Install the front No. 3 differential support with the 2 bolts.
![]() |
Install the front No. 2 differential support with the 2 bolts.
![]() |
Install the front No. 1 differential support with the 3 bolts.
Support the front differential with a jack.
![]() |
Install the 2 front mounting bolts and 2 nuts.
Install front differential mounting nut No. 1.
Install the front differential breather tube bracket with the bolt.
Lower the jack.
| 2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Coat the spline of the inboard joint shaft with ATF.
Align the shaft splines and install the drive shaft with a brass bar and hammer.
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
| 4. INSTALL FRONT LOWER BALL JOINT ATTACHMENT |
Install the front lower ball joint attachment with the 2 bolts.
| 5. INSTALL TIE ROD END SUB-ASSEMBLY LH |
![]() |
Install the tie rod end onto the steering knuckle.
Install the nut.
Install a new cotter pin.
| 6. INSTALL TIE ROD END SUB-ASSEMBLY RH |
| 7. INSTALL FRONT AXLE HUB NUT LH |
Install the hub nut.
Install the adjusting lock cap and a new cotter pin.
| 8. INSTALL FRONT AXLE HUB NUT RH |
| 9. INSTALL FRONT AXLE HUB GREASE CAP |
| 10. INSTALL FRONT SPEED SENSOR LH |
Install the skid control sensor wire onto the steering knuckle with the 2 bolts.
Engage the clamp.
Install the speed sensor with the bolt.
| 11. INSTALL FRONT SPEED SENSOR RH |
| 12. INSTALL FRONT WHEEL |
| 13. INSPECT DIFFERENTIAL OIL |
![]() |
Stop the vehicle on a level surface.
Remove the differential filler plug and gasket.
Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the differential filler plug hole.
| Item | Capacity | |
| Front Differential | w/o A.D.D. | 1.35 to 1.45 Liters (1.43 to 1.53 US qts, 1.19 to 1.28 Imp qts.) |
| w/ A.D.D. | 1.50 to 1.60 Liters (1.59 to 1.69 US qts, 1.32 to 1.41 Imp qts.) | |
| Rear Differential | w/o Differential Lock | 2.45 to 2.55 Liters (2.59 to 2.69 US qts, 2.16 to 2.24 Imp qts.) |
| w/ Differential Lock | 2.40 to 2.50 Liters (2.54 to 2.64 US qts, 2.11 to 2.20 Imp qts.) | |
Check for oil leakage when the oil level is low.
Install the differential filler plug with a new gasket.
| 14. CHECK FOR DIFFERENTIAL OIL LEAKAGE |
| 15. INSTALL REAR ENGINE UNDER COVER ASSEMBLY |
| 16. INSTALL NO. 1 ENGINE UNDER COVER |
| 17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 18. CHECK VSC SENSOR SIGNAL |
| 19. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |