OCCUPANT CLASSIFICATION SYSTEM > PRECAUTION |
| 1.INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT |
Perform the zero point calibration and sensitivity check if any of the following conditions apply.
| 2.DISCONNECT AND RECONNECT CABLE OF NEGATIVE BATTERY TERMINAL |
Before performing electric work, disconnect the cable from the negative (-) battery terminal in order to prevent it from shorting and burning out.
When disconnecting and reconnecting the battery cable, turn the ignition switch OFF and headlight dimmer switch OFF. then loosen the terminal nut completely. Be careful not to damage the cable or terminal.
When the battery cable is disconnected, the settings of the clock and radio, memory of DTCs, etc. are erased. Before disconnecting the battery cable, take notes of the settings and memory.
| System Name | See procedure |
| Meter / gauge system |
Click here
|