Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Broadcast cannot be Received or Poor Reception

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK RADIO RECEIVER ASSEMBLY
  1. Check the radio automatic station search function.

    1. Check the radio automatic station search function by activating it.
      Result 
      Result
      Proceed to
      Automatic station search function stops on a station
      A
      Automatic station search function does not stop
      B



B
Go to step 2
A

REPLACE RADIO RECEIVER ASSEMBLY (Click here)  

2.CHECK OPTIONAL COMPONENTS
  1. Check for optional components (sunshade film, telephone antenna, etc.).

    1. Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
      Result 
      Result
      Proceed to
      Optional components are installed
      A
      Optional components are not installed
      B

      NOTICE:
      Do not remove any optional components installed by the customer without his or her consent.



B
Go to step 3
A

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE) 

3.CHECK RADIO RECEIVER ASSEMBLY


    E187251
  1. Preparation for check

    1. Remove the antenna plug from the radio receiver assembly.

  1. Check for noise

    1. Turn the ignition switch to ACC with the radio receiver assembly connector connected.

    2. Turn the radio on and tune into AM mode.

    3. Place a screwdriver, thin wire or other metal object on the radio receiver assembly antenna jack and check that noise can be heard from the speakers.

      OK:
      Noise can be heard from the speaker.



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


4.INSPECT RADIO RECEIVER ASSEMBLY


    E188455E22
  1. Disconnect the RA1 radio receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    RA1-5 (ANT+) - Body ground
    Ignition switch ACC
    Radio switch on
    11 to 14 V

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


5.CHECK ANTENNA CORD
  1. Remove the antenna plug of the radio receiver assembly and antenna.

  1. Measure the resistance between the antenna and radio receiver assembly to check for an open circuit in the antenna cord.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the antenna cord and body ground to check for a short circuit in the antenna cord.

    Standard Resistance:
    10 kΩ or higher



NG
REPLACE ANTENNA CORD (Click here)
OK

NORMAL OPERATION