OCCUPANT CLASSIFICATION ECU > INSTALLATION |
| 1. PRECAUTION |
| 2. INSTALL OCCUPANT CLASSIFICATION ECU |
Check that the ignition switch is turned to OFF.
Check that the negative (-) battery terminal is disconnected.
![]() |
Install the occupant classification ECU.
Connect the 2 connectors to the occupant classification ECU.
| 3. INSTALL FRONT SEAT ASSEMBLY RH |
![]() |
Insert the 2 locating pins through the 2 body holes, place the front seat in the most rearward position and make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 1 and then bolt 2 onto the front side.
Move the front seat to the most forward position, and then make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 3 and then bolt 4 onto the rear side.
Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.
![]() |
for Driver Side:
Connect the 2 buckle switch connectors.
w/ Front Seat Side Airbag:
Install the clamp.
![]() |
for Front Passenger Side:
Connect the connector.
w/ Front Seat Side Airbag:
Install the clamp.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 6. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).