Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.PROBLEM SYMPTOM CONFIRMATION

        NEXT


        4.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).
          Result 
          Result
          Proceed to
          Fault is not listed in Problem Symptoms Table
          A
          Fault is listed in Problem Symptoms Table
          B



        B.
        Go to step 6
        A


        5.BASED ON PROBLEM SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here).


        NEXT


        6.ADJUST, REPAIR OR REPLACE

          NEXT


          7.CONFIRMATION TEST

            NEXT

            END