AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K10-7 (MUTE) - Body ground | Ignition switch ACC, audio system is playing → Changing sources | Above 2.5 V → Below 0.5 V |
| *a | Component with harness connected (Stereo Component Amplifier Assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the E83 radio receiver assembly and K10 stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E83-7 (MUTE) - K10-7 (MUTE) | Always | Below 1 Ω |
| E83-7 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL) |
![]() |
Reconnect the K10 stereo component amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E83-7 (MUTE) - Body ground | Ignition switch ACC, audio system is playing | Above 2.5 V |
| *a | Front view of wire harness connector (to Radio Receiver Assembly) |
|
| ||||
| OK | ||
| ||