Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each audio system component connected to the AVC-LAN (communication bus) transfers the switch signals by the audio visual communication local area network.
If a short to +B or short to ground occurs in this AVC-LAN, the audio system will not function normally as communication is stopped.

INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY


    E194165E06
  1. Disconnect the E83*1 and E84 radio receiver assembly connectors.
    *1: w/ Stereo Component Amplifier Assembly

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    5 (ATX+) - 15 (ATX-)*1
    Always
    60 to 80 Ω
    9 (TXM+) - 10 (TXM-)
    Always
    60 to 80 Ω

    *1: w/ Stereo Component Amplifier Assembly
    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly (w/ Stereo Component Amplifier Assembly))
    *b
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR

HINT:
For details of the connectors, refer to Terminals of ECU (Click here).



  1. Referring to the following AVC-LAN wiring diagram, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.



    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.


      E194159E10



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. When disconnecting a slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the malfunctioning slave unit.

    OK:
    Master unit returns to normal operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE MALFUNCTIONING PARTS