DTC C1203 ECM Communication Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1203 | Information relating to engine drive source or destination stored in ECM does not match that stored in skid control ECU. |
|
| 1.CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).
|
| ||||
| OK | |
| 2.CHECK DTC (ENGINE CONTROL SYSTEM) |
Check if any DTC is recorded for the engine control system (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||