Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    43    ABS Control System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when the VSC system detects a malfunction in the ABS system. When DTC 43 is stored, there is no malfunction in the skid control ECU.

DTC Code
DTC Detection Condition
Trouble Area
43
ABS control system abnormal
ABS control system

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


INSPECTION PROCEDURE

1.CHECK ANTI-LOCK BRAKE SYSTEM
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check if an ABS DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC (ABS DTC) is not output
    A
    DTC (ABS DTC) is output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2.CONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)