Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1225    SM Solenoid Circuit

DTC    C1226    SA2 Solenoid Circuit

DTC    C1468    SFR Solenoid Circuit

DTC    C1469    SFL Solenoid Circuit

DTC    C146A    SRR Solenoid Circuit

DTC    C146B    SRL Solenoid Circuit

for Preparation Click here


DESCRIPTION

The solenoid goes on when signals are received from the skid control ECU and controls the pressure action on the wheel cylinders thus controlling the braking force.

DTC Code
DTC Detection Condition
Trouble Area
C1225
Open or short in SMCF circuit continues for 0.05 seconds or more.
Master cylinder solenoid
C1226
Open or short in SREA circuit continues for 0.05 seconds or more.
Master cylinder solenoid
C1468
Open or short in SFRH or SFRR circuit continues for 0.05 seconds or more.
Master cylinder solenoid
C1469
Open or short in SFLH or SFLR circuit continues for 0.05 seconds or more.
Master cylinder solenoid
C146A
Open or short in SRRH or SRRR circuit continues for 0.05 seconds or more.
Master cylinder solenoid
C146B
Open or short in SRLH or SRLR circuit continues for 0.05 seconds or more.
Master cylinder solenoid

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.RECONFIRM DTC

HINT:
These DTCs are set when a problem is identified in the master cylinder solenoid.
The solenoid circuit is in the master cylinder solenoid.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTCs are output before replacing the master cylinder solenoid.

  1. Clear the DTCs (Click here).

  1. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.

  1. Check if the same DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)