Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1257    Power Supply Drive Circuit

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is built into the hydraulic brake booster and drives the pump motor based on a signal from the skid control ECU.

DTC Code
DTC Detection Condition
Trouble Area
C1257
Open in pump motor input circuit
Master cylinder solenoid (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the master cylinder solenoid, perform zero point calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HYDRAULIC BRAKE BOOSTER PUMP MOTOR OPERATION
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Check the hydraulic brake booster pump motor operation.

    OK:
    Hydraulic brake booster pump operates.



NG
REPLACE MASTER CYLINDER SOLENOID (Click here)
OK


2.RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Reconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)