Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC will be output if the transponder key ECU does not detect that the unlock warning switch is ON even when the ignition switch is in the ON position. Under normal conditions, the unlock warning switch is ON when the ignition switch is in the ON position.

DTC No.
DTC Detection Condition
Trouble Area
B2780
"Unlock warning switch ON" is not detected when ignition switch is ON
  1. Wire harness
  2. Unlock warning switch
  3. Transponder key ECU

WIRING DIAGRAM


B151009E22


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.

1.READ VALUE USING TECHSTREAM
  1. Connect a Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester ON.

  1. Enter the following menus: Body Electrical / Immobiliser / Data List.

  1. According to the display on tester, read the "Data List".


Immobiliser: 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-

OK:
ON (Key is in ignition key cylinder) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU (Click here)  

2.INSPECT UNLOCK WARNING SWITCH


    B175504E01
  1. Remove the unlock warning switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Switch pushed
    (Key set)
    Below 1 Ω
    Switch free
    (Key removed)
    10 kΩ or higher

  1. Reinstall the unlock warning switch.



NG
REPLACE UNLOCK WARNING SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND)
  1. Disconnect the E21 unlock warning switch connector.



    B175505E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E21-2 - Body ground
    Always
    Below 1 Ω

  1. Reconnect the unlock warning switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH)


    B175506E03
  1. Disconnect the E79 transponder key ECU connector.

  1. Disconnect the E21 unlock warning switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E79-3 (KSW) - E21-1
    Always
    Below 1 Ω
    E21-1 - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the transponder key ECU connector.

  1. Reconnect the unlock warning switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU (Click here)