Home › DRIVE LINE ยท VF4B TRANSFER › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSFER ASSEMBLY
  1. Install the transfer onto the transmission.

  1. Install the 2 clamps and 8 bolts.

    Torque:
    24 N*m{ 244 kgf*cm , 17 ft.*lbf }



2. INSTALL MANUAL TRANSMISSION ASSEMBLY
(Click here)


3. INSTALL LOWER TRANSFER CASE PROTECTOR


C133827
  1. Install the protector with the 5 bolts.

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }

  1. Install the brake hose clamp.



4. ADD TRANSFER OIL
  1. Remove the case plug (for filler) and gasket.

  1. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.

    NOTICE:
    1. When adding oil, pour it slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new gasket and the case plug (for filler).

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



5. INSPECT FOR TRANSFER OIL LEAKAGE


6. INSPECT FOR EXHAUST GAS LEAK

HINT:
Perform "Inspection After Repairs" after repairing or replacing the exhaust system (Click here).