Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU


    C168862
  1. Install the tire pressure warning ECU with the nut.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Connect the tire pressure warning ECU connector.



2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH


    B133857
  1. Install the connectors to the instrument panel lower finish panel.

  1. Engage the claw and 2 clips and install the instrument panel lower finish panel.

  1. Install screw <A>.



3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    B133856
  1. Install the glove compartment door assembly with the 3 hinges while holding it horizontal.



    B133854E01
  1. Slightly flex the upper part of the glove compartment door assembly, and install the glove compartment door assembly.

  1. Install the glove compartment door stoppers onto the glove compartment door.



4. REGISTRATION TRANSMITTED ID
(Click here)


5. INSPECT TIRE PRESSURE WARNING SYSTEM
(Click here)