REAR VIEW MONITOR SYSTEM > Reverse Signal Circuit |

| 1.INSPECT INNER REAR VIEW MIRROR ASSEMBLY (REVERSE SIGNAL) |
![]() |
Disconnect the R6 inner rear view mirror assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| R6-3 (REV) - Body ground | Ignition switch ON, shift lever in R | 11 to 14 V |
| Ignition switch ON, shift lever in P | Below 1 V |
Reconnect the inner rear view mirror assembly connector.
|
| ||||
| OK | ||
| ||
| 2.SYSTEM CHECK |
Check the vehicle specifications.
| Result | Proceed to |
| Vehicle with automatic transmission | A |
| Vehicle with manual transmission | B |
|
| ||||
| A | |
| 3.INSPECT PARK/NEUTRAL POSITION SWITCH (IG SIGNAL) |
![]() |
Disconnect the B35 park/neutral position switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| B35-2 (RB) - Body ground | Ignition switch ON | 11 to 14 V |
Reconnect the park/neutral position switch connector.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (INNER MIRROR - PNP SWITCH) |
![]() |
Disconnect the R6 inner rear view mirror assembly connector.
Disconnect the B35 park/neutral position switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R6-3 (REV) - B35-1 (RL) | Always | Below 1 Ω |
| R6-3 (REV) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| NG | A |
| OK (A750E) | B |
| OK (A750F) | C |
Reconnect the inner rear view mirror assembly connector.
Reconnect the park/neutral position switch connector.
|
| ||||
|
| ||||
| A | ||
| ||
| 5.INSPECT BACK-UP LIGHT SWITCH (IG SIGNAL) |
![]() |
Disconnect the B42 back-up light switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| B42-2 - Body ground | Ignition switch ON | 11 to 14 V |
Reconnect the back-up light switch connector.
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (INNER MIRROR - BACK-UP LIGHT SWITCH) |
![]() |
Disconnect the R6 inner rear view mirror assembly connector.
Disconnect the B42 back-up light switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R6-3 (REV) - B42-1 | Always | Below 1 Ω |
| R6-3 (REV) - Body ground | Always | 10 kΩ or higher |
Reconnect the inner rear view mirror assembly connector.
Reconnect the back-up light switch connector.
|
| ||||
| OK | ||
| ||