METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| CAN communication DTC is not output | A |
| CAN communication DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (WATER TEMPERATURE METER OPERATION) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Water Temperature Meter Operation | Engine coolant temperature receiver gauge | OFF, LOW, NORMAL or HIGH | Perform the test with the vehicle stopped and the engine idling. |
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temperature | Engine coolant temperature/ Min.: 0 (32), Max.: 127.5 (261.5) | After warming up: 75 to 105 (167 to 221) | Unit: °C (°F) |
|
| ||||
| OK | |
| 4.CHECK ENGINE CONTROL SYSTEM |
Check if a engine control DTC is output (Click here).
| Result | Proceed to |
| Engine control DTC is not output | A |
| Engine control DTC is output | B |
|
| ||||
| A | ||
| ||