Home › BRAKE › BRAKE CONTROL › DRIVING SUPPORT SWITCH CONTROL ECU

DRIVING SUPPORT SWITCH CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL DRIVING SUPPORT SWITCH CONTROL ECU
  1. Install the driving support switch control ECU with the nut.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



2. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY
  1. Install the multi-media interface ECU assembly with the 2 nuts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Connect the 3 connectors and clamp.



3. INSTALL RADIO RECEIVER ASSEMBLY
(Click here)