Home › BODY ELECTRICAL › AUDIO / VISUAL › MULTI-MEDIA INTERFACE ECU

MULTI-MEDIA INTERFACE ECU > INSTALLATION

for Preparation Click here



1. INSTALL DRIVING SUPPORT SWITCH CONTROL ECU (w/ CRAWL)
  1. Install the driving support switch control ECU with the nut.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



2. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY
  1. Install the multi-media interface ECU with the 2 nuts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Connect the connectors and clamp.

  1. w/ CRAWL:

    1. Connect the connector.



3. INSTALL RADIO RECEIVER ASSEMBLY
(Click here)