FRONT SEAT ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT SEAT ASSEMBLY |
![]() |
Insert the 2 locating pins through the 2 body holes, place the front seat in the most rearward position and make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 1 and then bolt 2 onto the front side.
Move the front seat to the most forward position, and then make sure that the inner and outer seat tracks are locked securely.
Tighten bolt 3 and then bolt 4 onto the rear side.
Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.
![]() |
for Driver Side:
Connect the 2 buckle switch connectors.
w/ Front Seat Side Airbag:
Install the clamp.
![]() |
for Front Passenger Side:
Connect the connector.
w/ Front Seat Side Airbag:
Install the clamp.
| 2. INSTALL FRONT SEAT TRACK COVER |
![]() |
Insert the front seat track cover 2 guides in between the seat rail and the seat leg. Then slightly lift up the front seat track cover rear part and carefully push the front seat track cover in until it cannot be pushed in any further.
![]() |
Carefully insert the front seat track cover outside claw into the seat leg corner groove according to the procedure shown in the illustration.
Carefully push directly from the top of the front seat track cover inside claw to insert it into the seat leg corner groove, as shown in the illustration.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT SRS WARNING LIGHT |