STARTER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH |
Remove the exhaust manifold (Click here).
| 3. REMOVE STARTER COVER |
![]() |
Remove the 3 bolts and starter cover.
| 4. REMOVE STARTER ASSEMBLY |
![]() |
Remove the bolt and ground wire.
Disconnect the starter connector.
Open the terminal cap.
Remove the nut and bolt, and then disconnect the starter wire.
![]() |
Remove the 2 bolts and starter.
| 5. REMOVE FLYWHEEL HOUSING SIDE COVER |
![]() |