FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
![]() |
Install a new gasket onto the fuel tank.
Set the fuel suction tube assembly to the fuel tank.
![]() |
Fit the spline of the fuel suction tube assembly into the keyway of the fuel tank.
Install a new retainer.
![]() |
Align the mark on a new retainer with the rib on the fuel tank as shown in the illustration.
| *1 | Start Mark (Fuel Tank Side) |
| *2 | Start Mark (Retainer Side) |
Set the plate and claws of SST onto the fuel pump gauge retainer and temporarily tighten the bolts.
While firmly pressing the claws of SST against the ribs of the retainer, fully tighten each bolt.
Set SST handle in place.
![]() |
Using SST, turn the retainer 740° to 760° clockwise (more than 2 turns), and position the mark on the retainer within range A to install it.
| *1 | Fuel Tank Side Mark |
| *2 | Retainer Side Mark |
| 2. INSTALL FUEL TANK ASSEMBLY |
Install the fuel tank assembly (Click here).