INTUITIVE PARKING ASSIST SYSTEM > Clearance Sonar Main Switch Circuit |

| 1.INSPECT BACK SONAR SWITCH ASSEMBLY |
Inspect the back sonar switch assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BACK SONAR SWITCH ASSEMBLY - CLEARANCE WARNING ECU) |
Disconnect the E12 back sonar switch assembly connector.
Disconnect the E80 clearance warning ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E12-3 - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E12-4 - E80-10 (IG) | Always | Below 1 Ω |
| E12-6 - Body ground | ||
| E80-21 (E) - Body ground | ||
| E80-10 (IG) - Body ground | Always | 10 kΩ or higher |
Reconnect the back sonar switch connector.
Reconnect the clearance warning ECU connector.
|
| ||||
| OK | |
| 3.INSPECT CLEARANCE WARNING ECU ASSEMBLY |
![]() |
Remove the clearance warning ECU with its connector still connected.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E80-10 (IG) - E80-21 (E) | Ignition switch ON, back sonar switch ON | 11 to 14 V |
| *a | Component with harness connected (Clearance Warning ECU) |
Reinstall the clearance warning ECU.
|
| ||||
| OK | ||
| ||