WIPER AND WASHER SYSTEM > Rear Wiper Motor Circuit |

| 1.CHECK DTC OUTPUT |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs.
Check whether DTC B1214, B1215 or B1287 recurs 10 seconds or more after the ignition switch is turned on.
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (REAR WIPER) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Back Door / Active Test / Rear Wiper.
Check the rear wiper while operating the back door ECU using the tester.
| Tester Operation | Specified Condition |
| Rear Wiper OFF | Rear wiper off |
| Rear Wiper ON | Rear wiper operates |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (BACK DOOR ECU - BATTERY, IGNITION SWITCH, BODY GROUND) |
![]() |
Disconnect the S2 back door ECU connector.
Measure the voltage.
| Tester Connection | Switch Condition | Specified Condition |
| S2-4 (BDR) - Body ground | Always | 11 to 14 V |
| S2-5 (BECU) - Body ground | Always | 11 to 14 V |
| S2-6 (SIG) - Body ground | Ignition Switch OFF → ON | Below 1 V → 11 to 14 V |
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| S2-3 (GND) - Body ground | Always | Below 1 Ω |
Reconnect the back door ECU connector.
|
| ||||
| OK | |
| 4.INSPECT REAR WIPER MOTOR ASSEMBLY |
![]() |
Remove the rear wiper motor assembly.
Connect the battery's positive (+) lead to terminal 5 (L) and the negative (-) lead to terminal 4 (E).
Check that the rear wiper motor operates.
Reinstall the rear wiper motor assembly.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (REAR WIPER MOTOR ASSEMBLY - BACK DOOR ECU) |
![]() |
Disconnect the S3 rear wiper motor assembly connector.
Disconnect the S5 back door ECU connector.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| S5-1 (WIP-) - S3-4 (E) | Always | Below 1 Ω |
| S5-2 (WIP+) - S3-5 (L) | Always | Below 1 Ω |
| S5-3 (W) - S3-3 (W) | Always | Below 1 Ω |
| S5-12 (P) - S3-1 (P) | Always | Below 1 Ω |
| S5-18 (SGND) - S3-2 (E) | Always | Below 1 Ω |
| S5-2 (WIP+) - Body ground | Always | 10 kΩ or higher |
| S5-3 (W) - Body ground | Always | 10 kΩ or higher |
| S5-12 (P) - Body ground | Always | 10 kΩ or higher |
Reconnect the the rear wiper motor assembly connector.
Reconnect the back door ECU connector.
|
| ||||
| OK | ||
| ||