Home › DRIVE LINE ยท DIFFERENTIAL › FRONT DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL

FRONT DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the RH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.



1. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


B084278E01
  1. Apply MP grease to 2 new oil seals.

  1. Using SST and a hammer, tap in the 2 oil seals.

    SST
    09550-00032  
    09950-70010   (09951-07100)

    Oil seal depth:
    Side
    Oil Seal Depth
    LH side
    -0.45 to 0.45 mm (-0.018 to 0.018 in.)
    RH side
    4.8 to 5.8 mm (0.189 to 0.229 in.)

    NOTICE:
    Make sure the LH and RH oil seals are installed in the proper locations.



2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(Click here)