Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING RESET SWITCH
  1. Engage the 2 claws and install the tire pressure warning reset switch to the lower instrument panel finish panel sub-assembly LH.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B133860
  1. Engage the 5 clips and claw and install the lower instrument panel finish panel.

  1. Connect the connector.

  1. Install the 2 <F> bolts.



3. INSTALL INSTRUMENT PANEL FINISH PLATE


E149563E01
  1. Install the instrument panel finish plate.



4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Engage the 3 claws and install the hood lock control lever.



5. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



6. INSTALL COWL SIDE TRIM BOARD LH


E129563
  1. Engage the 2 claws and install the cowl side trim board.

  1. Install the clip.



7. INSTALL FOOTREST CLIP


B130588

HINT:
Use the same procedure for both sides.

  1. Engage the 2 claws and install the footrest clip.



8. INSTALL FRONT FLOOR FOOTREST


    B130589
  1. Engage the 2 studs and install the front floor footrest.



9. INSTALL FRONT DOOR SCUFF PLATE LH


E129562
  1. Engage the 14 claws and install the door scuff plate.



10. INSPECT TIRE PRESSURE WARNING SYSTEM
(Click here)