Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › VVT SENSOR

VVT SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 EMISSION CONTROL VALVE SET
(Click here)


2. REMOVE AIR CLEANER HOSE ASSEMBLY


    A221455
  1. Loosen the hose clip and disconnect the ventilation hose from the air cleaner hose assembly.

  1. Disconnect the vacuum hose from the air cleaner hose assembly.

  1. Disengage the clamp and disconnect the wire harness from the air cleaner hose assembly.

  1. Remove the bolt and disconnect the air cleaner hose assembly from the resonator bracket.

  1. Loosen the 2 hose clamps and remove the air cleaner hose assembly from air cleaner cap sub-assembly and intake air surge tank.



3. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    A221424
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.



4. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    A221425
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.



5. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    A221426
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.



6. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    A221427
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.