Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE GENERATOR ASSEMBLY
  1. Remove the generator (Click here).



2. SEPARATE COOLER COMPRESSOR ASSEMBLY

HINT:
It is not necessary to completely remove the compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.

  1. Disconnect the cooler compressor connector.



    A225902
  1. Remove the bolt and separate the suction hose.



    A225903
  1. Remove the 3 bolts and nut.

  1. Using a E8 "TORX" socket wrench, remove the stud bolt and separate the cooler compressor assembly.



3. REMOVE CRANKSHAFT POSITION SENSOR


    A226622
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.