Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR


    A078438E15
  1. Install the 2 sensors with the 2 bolts as shown in the illustration.
    Text in Illustration 
    *a
    for Bank 2:
    *b
    for Bank 1:
    *c
    Engine Rear
    *d
    Top
    *e
    Engine Front

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    HINT:
    Perform "Inspection After Repairs" after replacing the knock sensor (Click here).

  1. Connect the 2 sensor connectors.



2. INSTALL NO. 1 WATER OUTLET PIPE
  1. Install the No. 1 water outlet pipe with the 2 nuts and bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the 4 wire harness clamps.



3. INSTALL CYLINDER HEAD SUB-ASSEMBLY (for Bank 1)
  1. Install the cylinder head (Click here).