Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. REMOVE CYLINDER HEAD SUB-ASSEMBLY (for Bank 1)
  1. Remove the cylinder head (Click here).



2. REMOVE NO. 1 WATER OUTLET PIPE


    A178539
  1. Disconnect the 4 wire harness clamps.

  1. Remove the 2 nuts, bolt and No. 1 water outlet pipe.



3. REMOVE KNOCK SENSOR


    A075662
  1. Disconnect the 2 sensor connectors.

  1. Remove the 2 bolts and 2 sensors.