Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the 4 claws and the 2 pins and install the steering pad.

  1. Tighten the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the connector and 3 guides.

  1. w/ Cruise Control System:

    1. Connect the cruise control switch connector.



2. INSTALL STEERING PAD


    C128255E01
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the circumferencial groove of the "Torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using "Torx" socket wrench (T30), tighten the 2 "Torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.



3. INSTALL STEERING WHEEL LOWER COVER LH


    C128195
  1. Install steering wheel cover lower No.3.



4. INSTALL STEERING WHEEL LOWER COVER RH


    C128196
  1. Install steering wheel cover lower No.2.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. INSPECT SRS WARNING LIGHT
(Click here)