Home › ENGINE › 1GR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL FRONT CRANKSHAFT OIL SEAL


A221100E01
  1. Apply MP grease to the lip of a new oil seal.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

    SST
    09226-10010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap the oil seal at an angle.



2. INSTALL CRANKSHAFT PULLEY


A076309E03
  1. Using SST, install the crankshaft pulley to the crankshaft with the pulley set bolt.

    SST
    09213-54015   (91651-60855)
    09330-00021  

    Torque:
    260 N*m{ 2651 kgf*cm , 192 ft.*lbf }



3. INSTALL OIL FILTER BRACKET
  1. Install the oil filter bracket and new gasket to the oil pan sub-assembly with the 2 nuts and bolt.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



4. INSTALL FAN SHROUD
  1. Install the fan shroud (Click here).



5. INSPECT FOR ENGINE OIL LEAK


6. INSPECT FOR COOLANT LEAK