Home › ENGINE › 1GR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FAN SHROUD
  1. Remove the fan shroud (Click here).



2. REMOVE OIL FILTER BRACKET


A225998
  1. Remove the 2 nuts, bolt, oil filter bracket and gasket from the oil pan sub-assembly.



3. REMOVE CRANKSHAFT PULLEY


A072947E04
  1. Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A072948E02
  1. Using the pulley set bolt and SST, remove the crankshaft pulley and pulley bolt from the crankshaft.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05031)



4. REMOVE FRONT CRANKSHAFT OIL SEAL


A221099
  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.