Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends the microphone signal from the inner rear view mirror assembly (telephone microphone) to the radio receiver assembly.
It also supplies power source from the radio receiver assembly to the inner rear view mirror assembly (telephone microphone).

WIRING DIAGRAM


E219922E02


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY


    E195982E12
  1. Disconnect the E85 radio receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (MACC) - Body ground
    Ignition switch ON
    4 to 6 V

    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E85-5 (MIN-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - RADIO RECEIVER ASSEMBLY)
  1. Disconnect the R6 inner rear view mirror assembly and E85 radio receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R6-11 (MI1+) - E85-2 (MIN+)
    Always
    Below 1 Ω
    R6-12 (MI1-) - E85-5 (MIN-)
    Always
    Below 1 Ω
    R6-9 (ACC) - E85-3 (MACC)
    Always
    Below 1 Ω
    R6-11 (MI1+) - Body ground
    Always
    10 kΩ or higher
    R6-12 (MI1-) - Body ground
    Always
    10 kΩ or higher
    R6-9 (ACC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT INNER REAR VIEW MIRROR ASSEMBLY (TELEPHONE MICROPHONE)


    E219924E01
  1. Reconnect the radio receiver assembly connector.

  1. Reconnect the inner rear view mirror assembly connector.

  1. Turn the ignition switch to ACC.

  1. Connect an oscilloscope to terminals R6-11 (MI1+) and R6-12 (MI1-) of the inner rear view mirror assembly connector.

  1. Check the waveform of the telephone microphone assembly using an oscilloscope.
    Result 
    Result
    Proceed to
    A waveform synchronized with the voice input to the telephone microphone assembly is output
    A
    A waveform synchronized with the voice input to the telephone microphone assembly is not output
    B

Text in Illustration 
*a
Component with harness connected
(Inner rear view mirror assembly)


B
REPLACE INNER REAR VIEW MIRROR ASSEMBLY (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)