Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A171097E01
  1. Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly LH.
    Text in Illustration 
    *a
    Fulcrum Length 300 mm (11.18 in.)
    *b
    Fulcrum Length 30 mm (1.18 in.)

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    Do not use an air fuel ratio sensor that has been dropped or subjected to a strong impact.

    HINT:
    1. This torque value is effective when SST is parallel to the torque wrench.
    2. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    3. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).
    4. If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (Click here).
    5. Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).



2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A171098E01
  1. Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly RH.
    Text in Illustration 
    *a
    Fulcrum Length 300 mm (11.18 in.)
    *b
    Fulcrum Length 30 mm (1.18 in.)

    SST
    09224-00010  

    NOTICE:
    Do not use an air fuel ratio sensor that has been dropped or subjected to a strong impact.

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. This torque value is effective when SST is parallel to the torque wrench.
    2. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    3. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).
    4. If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (Click here).
    5. Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).



3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
(Click here)


4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(Click here)