Home › STEERING › POWER STEERING › POWER STEERING LINK

POWER STEERING LINK > REMOVAL

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. SECURE STEERING WHEEL


    C137982
  1. Secure the steering wheel with the seat belt in order to prevent it from rotating.

    HINT:
    This operation is necessary to prevent damage to the spiral cable.



3. REMOVE FRONT WHEELS


4. REMOVE ENGINE ASSEMBLY
(Click here)


5. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY


F043317E01
  1. Mark matchmarks on the power steering gear assembly and No. 2 steering intermediate shaft.

  1. Remove bolt C and the No. 2 steering intermediate shaft from the power steering gear assembly.



6. SEPARATE TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    F051679E01
  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



7. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side as for the LH side.



8. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


    C215750
  1. Remove the clip and disconnect the pressure feed tube assembly (return tube side) from the power steering link assembly.



    C234519
  1. Using a union nut wrench (17 mm), disconnect the pressure feed tube assembly (pressure feed tube side) from the power steering link assembly.



    C234520
  1. Remove the 2 bolts and separate the pressure feed tube clamp.



9. REMOVE POWER STEERING LINK ASSEMBLY


    C234521
  1. Remove the 2 bolts, 2 nuts and the power steering link assembly.