Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

for Preparation Click here


INSPECTION PROCEDURE

NOTICE:
  1. Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, the broadcast will not be able to be listened to or viewed.
  1. After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, the XM Radio ID registration is necessary.

1.CHECK RADIO RECEIVER ASSEMBLY
  1. Check radio condition.
    Result 
    Result
    Proceed to
    Broadcast cannot be selected
    A
    Broadcast can be selected, but selection cannot be memorized
    B



B
Go to step 2
A

ADD PRESET CHANNEL INTO MEMORY AGAIN 

Go to step 4

2.CHECK RADIO RECEIVER ASSEMBLY (RADIO RECEIVER)
  1. Check the number of preset channels.

    OK:
    18 channels have already been preset.



NG
Go to step 3
OK

END (ONLY 18 CHANNELS CAN BE PRESET) 

3.CHECK BATTERY
  1. Check if the battery was replaced.

    OK:
    Battery was not replaced.



NG
Go to step 4
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)  

4.ADD PRESET CHANNEL INTO MEMORY AGAIN
  1. Check if the preset channels that have been cleared can be added into memory again.

    OK:
    Preset channels can be added into memory.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END