Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    CB-10    System Microcomputer Malfunction

DTC    CB-11    Media Interface Microcomputer Malfunction

DTC    CB-12    CD-LSI Malfunction

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
CB-10
System microcomputer malfunction
  1. Multi-media interface ECU
  2. USB device or "iPod"
CB-11
Media interface microcomputer malfunction
CB-12
CD-LSI (large scale integration) Malfunction

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE