CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit |
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE MAIN INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | Cruise main indicator light | ON/OFF | Confirm that the vehicle is stopped with the engine idling. |
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (CRUISE CONTROL SWITCH) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Main SW M-CPU | Cruise control switch (Main CPU) / OFF or ON | OFF: Cruise control switch off ON: Cruise control switch on | - |
|
| ||||
| OK | ||
| ||