VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light does not Come ON |
| 1.CHECK DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Slip | Slip indicator light | OFF/ON | Perform the test with the vehicle stopped and the engine idling. |
|
| ||||
| OK | ||
| ||
| 4.PERFORM ACTIVE TEST USING TECHSTREAM |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Slip Indicator Light | Slip indicator light | Indicator light OFF/ON | Observe the combination meter. |
Using the Techstream, check that the Data List display changes from OFF to ON.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Slip Indicator Light | Slip indicator light/ ON or OFF | ON: Indicator light on OFF: Indicator light off | - |
|
| ||||
| OK | ||
| ||