DTC C1452 Accumulator Low Pressure |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1452 | After braking, the fluid pressure inside the accumulator is below the threshold within 3.2 seconds. |
|
| 1.CUSTOMER PROBLEM ANALYSIS |
Check with the customer to determine if frequent braking has been performed.
| NEXT | |
| 2.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Wait for 99 seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| Frequent braking was not performed and DTC is not output | B |
| Frequent braking was performed and DTC is not output | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK HYDRAULIC CIRCUIT |
Check the hydraulic circuit (Click here).
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (ACCUMULATOR SENSOR) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Accumulator Sensor | Accumulator pressure sensor reading / min.: 0 V, max.: 5 V | 3.58 to 5 V | If value constant regardless of pump operation, accumulator pressure sensor malfunction suspected. |
Check that the accumulator's output value is in the Normal Condition range.
|
| ||||
| OK | |
| 5.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||