STEERING KNUCKLE > INSTALLATION |
| 1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY |
Fix the steering knuckle in the vise using aluminium plates.
Install the front lower ball joint assembly to the steering knuckle with the nut.
Install a new cotter pin to the front lower ball joint assembly.
| 2. INSTALL STEERING KNUCKLE |
![]() |
Install the steering knuckle and brake dust cover to the front axle hub sub-assembly with the 4 bolts.
| 3. INSTALL FRONT AXLE ASSEMBLY |
Temporarily install the front axle assembly to the front suspension upper arm and front suspension lower arm.
![]() |
Fully tighten front suspension lower arm with the 4 bolts and 4 nuts.
![]() |
Fully tighten the front suspension upper arm with the nut.
Install a new cotter pin to the front suspension upper arm.
| 4. INSTALL TIE ROD END SUB-ASSEMBLY |
Install the tie rod end sub-assembly to the steering knuckle with the castle nut.
Install a new cotter pin to the tie rod end sub-assembly.
| 5. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the brake caliper assembly to the steering knuckle with the 2 bolts.
| 6. INSTALL FRONT SPEED SENSOR (w/ ABS) |
![]() |
Install the speed sensor to the steering knuckle with the 2 bolts.
| 7. INSTALL FRONT WHEEL |
| 8. INSPECT WHEEL ALIGNMENT |
| 9. CHECK ABS SPEED SENSOR SIGNAL (w/ ABS) |