Home › TRANSMISSION ยท CLUTCH › CLUTCH MASTER CYLINDER

CLUTCH MASTER CYLINDER > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS


    C102640E02
  1. Install the lock nut to the push rod.

  1. Install the push rod clevis and temporarily tighten the lock nut.

    HINT:
    1. Be sure to install the lock nut at the same position as before removal.
    2. Fully tighten the lock nut when adjusting the clutch pedal.



2. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY


    C102638
  1. Install the clutch master cylinder with the 2 nuts.

    Torque:
    14 N*m{ 145 kgf*cm , 10 ft.*lbf }



    C102635E01
  1. Apply MP grease to the sliding portions of the push rod clevis and clutch pedal.

  1. Install the push rod clevis to the cutout of the pedal from the right side of the vehicle and push it downward.

    NOTICE:
    Check that the push rod cannot be turned 30° or more in order to confirm that the clevis is securely engaged in the pedal.



    C102639E01
  1. Using SST, connect the clutch tube to the clutch master cylinder.

    SST
    09023-00101  

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }

  1. Connect the clutch reservoir tube with the clip.

    NOTICE:
    Face the yellow mark upward.



3. INSTALL WASHER TANK AND PUMP ASSEMBLY


4. ADD BRAKE FLUID


C106088

Fluid:
SAE J1704 or FMVSS No. 116 DOT3 or equivalent



5. BLEED CLUTCH LINE
  1. Fill the brake reservoir tank with clutch fluid and bleed the clutch system.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }



6. CHECK FOR BRAKE FLUID LEAKAGE

HINT:
Check for leakage in the clutch system.



7. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1704 or FMVSS No.116 DOT3 or equivalent



8. INSPECT AND ADJUST CLUTCH PEDAL HEIGHT
(Click here)