Home › ENGINE ยท 5L-E › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. REMOVE BATTERY SERVICE HOLE COVER


2. SEPARATE CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FRONT DOOR SCUFF PLATE RH


4. REMOVE FRONT SEAT ASSEMBLY (for Hi-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)



5. REMOVE FRONT SEAT ASSEMBLY (for Low-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)



6. REMOVE ECM
  1. Separate the floor carpet.



    A102286
  1. Separate the 2 clips and 4 connectors.

  1. Remove the ECM with the cover.



    A102887E01
  1. Remove the 4 bolts and the ECM cover.